Pair the remote to your light
Updated 16 days ago
A smart light only responds to the remote paired with it. They come paired out of the box: put the battery in and the remote works. You only need these steps after a controller swap (with the conversion kit), with a replacement remote, or if a remote has been unpaired.
These steps are for the Haylen (Smart Lights), the Haylen RGB (Smart Lights) and the conversion kit remote. For any other light, use the remote guide that came with it, or find it under Installation Guides.
Pair the remote
- Switch the light on at the wall and let it come on fully. It fades on slowly.
- Switch it off at the wall for 5 to 10 seconds, then back on.
- Within 10 seconds, press and hold ON on the remote until the light blinks three times, then let go. The small light on the remote should stay lit while you hold.
- Press any button on the remote. The light should respond. If it didn't blink, switch it off at the wall and start again from step 2.
Unpair a remote
If a remote controls a light it shouldn't, do the same power cycle, then press and hold OFF until the light blinks three times.
One remote, several lights
If holding one remote makes several lights blink, that remote is paired with all of them. That's fine for everyday use, but the app pairs one light at a time, so give each light its own remote first. Switch every other light off at the wall, unpair the remote that shouldn't control it, pair the right one, then move on to the next light.
Good to know
- Use the remote that came with that type of light. A Haylen RGB remote doesn't pair with a Haylen Smart, and a Haylen Smart remote doesn't pair with a Haylen RGB.
- After a conversion kit, the old remote no longer works with the light. A converted light that stays on one color and ignores the old remote is normal. Pair the new remote.
- On the Haylen (Smart Lights), the remote moves between warmer and cooler white. Colors are for the RGB version.
- Once the remote controls the light, you can pair the light to the app. See Pair a light to the app. The remote's pairing button puts the light into pairing mode, so the app can't find the light until the remote works.
Was this article helpful?
Still need help?
Our team answers by message, chat and phone.
Or call +1 888 988 4317, Monday to Friday, 9 AM to 8 PM ET.